Cisco Cisco Packet Data Gateway (PDG)
ACS Ruledef Configuration Mode Commands
▀ ftp state
▄ Command Line Interface Reference, StarOS Release 16
846
ftp state
This command allows you to define rule expressions to match the current state of an FTP session.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] ftp state operator ftp_state
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
ftp_state
Specifies the FTP state to match.
ftp_state
must be one of the following:
close
: FTP transmissions that are in closed state.
command-sent
: FTP transmissions that are in command-sent state.
response-error
: FTP transmissions that are in response-error state.
response-ok
: FTP transmissions that are in response-ok state.
Usage
Use this command to define rule expressions to match the current state of an FTP session.
Example
The following command defines a rule expression to match FTP current state
close
:
ftp state = close