Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
▀ ip address secondary-pool
▄ Command Line Interface Reference, StarOS Release 16
8534
ip address secondary-pool
Configures secondary IP address pool properties for the subscriber to provide multiple IP host configuration behind one
WiMAX Customer Premise Equipment (CPE).
WiMAX Customer Premise Equipment (CPE).
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
[ no ] ip address secondary-pool name aux_pool_name
no
Removes a previously configured auxiliary pool named
aux_pool_name
for multiple host support in ASN-
GW service.
ip address secondary-pool name
aux_pool_name
Specifies the secondary/auxiliary IP address pool or IP address pool group from which the IP address is
assigned to host behind a WiMAX CPE having primary IP address.
assigned to host behind a WiMAX CPE having primary IP address.
pool_name
must be the name of an existing IP pool or IP pool group expressed as an alphanumeric string of
1 through 31 characters.
Usage
Use this command to specify the name of an IP address pool configured on the system from which IP
addresses are to be dynamically assigned to host behind a WiMAX CPE for multiple host session support.
This command designates the IP address to secondary hosts from locally configured secondary IP address
pool. To enable multiple host support behind a WiMAX CPE and configure maximum number of supported
hosts use
addresses are to be dynamically assigned to host behind a WiMAX CPE for multiple host session support.
This command designates the IP address to secondary hosts from locally configured secondary IP address
pool. To enable multiple host support behind a WiMAX CPE and configure maximum number of supported
hosts use
secondary-ip-host
command in ASN Gateway Service Configuration mode.
Example
The following command configures the subscriber to receive IP addresses from a secondary IP address pool
named
named
auxiliary1
for secondary hosts behind the WiMAX CPE:
ip address secondary-pool name auxiliary1