Cisco Cisco Packet Data Gateway (PDG)
Troubleshooting the Service
Test Commands ▀
HNB-GW Administration Guide, StarOS Release 17 ▄
137
Important:
This command must be executed from within the context in which at least one HNB-GW
service is configured.
The command has the following syntax:
gtpv0 test echo src-address src_ip_address { all | sgsn-address ip_address }
Keyword/Variable
Description
src-address
src_ip_address
Specifies the IP address of an interface configured on the system.
NOTE: The IP address of the system’s interface must be bound to a configured HNB-GW service
prior to executing this command.
prior to executing this command.
all
Specifies that GTP-U echo requests will be sent to all Nodes that currently have sessions with the
HNB-GW service.
HNB-GW service.
sgsn-address
ip_address
Specifies that GTPv0 echo requests will be sent to a specific SGSN.
ip_address
is the address
of the SGSN to receiving the requests.
The following figure displays a sample of this command’s output showing a successful GTPv0 echo-test from an HNB-
GW service bound to address 192.168.157.32 to an SGSN with an address of 192.168.157.2.
GW service bound to address 192.168.157.32 to an SGSN with an address of 192.168.157.2.
GTPv0 test echo
--------------
SGSN: 192.168.157.2 Tx/Rx: 1/1 RTT(ms):14 (COMPLETE)Recovery: 210(0xD2)
Using the IPsec Tunnel Test Command
This command tests the system’s ability to communicate through an IPsec Tunnel. This functionality is useful for
troubleshooting and/or monitoring.
troubleshooting and/or monitoring.
The command has the following syntax:
test ipsec tunnel ip-pool ip_pool_name destination-ip des_ip_address source-ip
src_ip_address
src_ip_address
Keyword/Variable
Description
ip_pool_name
The name of the IP pool configured for IPsec Tunnel.
ip_pool_name
can be from 1 to 63 alpha and/or
numeric characters in length and is case sensitive.
des_ip_address
The IP address of destination node of IPsec tunnel.
src_ip_address
The IP address of source node of IPsec tunnel.