Cisco Cisco Packet Data Gateway (PDG)

Seite von 642
  MME Changes in Release 16 
MME Enhancements for 16.1  ▀   
 
Release Change Reference, StarOS Release 16  ▄  
 
   
257 
 
Path Destination IP Address 
 
Path State 
 
Flow Id 
show sgs-service vlr-status full
 
The output of this command has been enhanced to display the SCTP flow id. For example: 
Assoc Path State 
  192.80.80.41 192.80.80.33 UP 
0x1b046db
 
CSCup32019 - SLs: MME needs to handle S10 TAU (AF not set) for NI-LR lcs 
procedure  
Feature Changes 
Behavior Change for Emergency TAU Attach Without Active Flag Set 
 
Previous Behavior:  During a TAU attach, when Active Flag (AF) is not set in TAU request, the UE is moved to idle 
state. 
New Behavior:  During inbound TAU of emergency calls, the UE will be moved to connected state even when AF is 
not set, so that the NI-LR LCS procedure can be successful. This is done only if it is an emergency call and location 
service is configured. If it is not an emergency call, then the previous behavior will be valid and the UE will move to 
idle state when AF is not set. 
Customer Impact:  Support of NI-LR for inbound emergency TAU attach. 
CSCzn11186 - MME support for SBc interface (SBc-AP) to Cell broadcast 
center (CBC)  
Feature Changes 
SBc-AP interface Support
 
Important:
  For this release, this feature is Lab/Trial Quality only. 
Previous Behavior:  The SBc-AP interface was not supported. 
New Behavior:   The MME now provides support for Commercial Mobile Alert System (CMAS): SBc interface and 
underlying protocols. Warning Messages can now be received from a Cell Broadcast Center (CBC) over the SBc-AP 
interface and relayed to all relevant eNodeBs over the S1-AP interface. 
The MME complies with the following standards relating to this functionality: 
 
3GPP TS29.168 v10.2.0 – Cell Broadcast Centre interfaces with the Evolved Packet Core