Cisco Cisco Packet Data Gateway (PDG)

Seite von 642
PSF Changes in Release 16   
▀  PSF Enhancements for 16.0 
 
 
▄  Release Change Reference, StarOS Release 16 
312 
   
PSF Enhancements for 16.0 
This section identifies all of the Firewall enhancements included in this release: 
Feature Changes - new or modified features or behavior changes. For details, refer to the PSF Administration Guide 
for this release. 
Command Changes - changes to any of the CLI command syntax. For details, refer to the Command Line Interface 
Reference
 for this release. 
Performance Indicator Changes - new, modified, and deprecated bulk statistics, disconnect reasons, counters and/or 
fields in new or modified schema and/or show command output. For details, refer to the Statistics and Counters 
Reference
 for this release. 
CSCtl88372 - SFW: feature parity of the PSFW between uplink and downlink 
Applicable Products: GGSN, HA, IPSG, PDSN, P-GW 
Feature Changes 
Firewall Uplink Protection
 
The Firewall Uplink protection feature provides security to ISP servers from mobile space devices. In addition to 
protecting mobiles from Internet vulnerabilities, it is imperative to protect ISP servers from the mobile space originated 
traffic. Feature Parity of Firewall is aimed at porting all Downlink protection features to support Uplink servers as well. 
No separate license is required to enable this feature. 
The following features will be ported to support Uplink protection. 
 
IP Options check 
 
Jolt attack detection 
 
Teardrop attack detection 
 
Winnuke attack detection 
 
Ping of Death attack detection 
 
TCP Sequence number and ACK Number checks 
 
MIME Flood attack detection 
 
TCP RST message threshold 
 
UDP - ICMP Destination Unreachable message threshold 
 
ICMP - ICMP Destination Unreachable message threshold 
For uplink protection, no additional statistics are added. All the existing statistics will be pegged properly with uplink 
protection enabled. Uplink Flooding detection, Uplink Port-scan detection and Uplink IP-sweep protection will be 
enabled separately in Global ACS Service Configuration mode. 
Command Changes 
firewall protect-servers