Cisco Cisco Packet Data Gateway (PDG)
Configuring the SaMOG Gateway
Configuring the System to Perform as a SaMOG Gateway ▀
SaMOG Administration Guide, StarOS Release 17 ▄
57
radius client ip4_address/subnetmask encrypted key key disconnect-message dest-
port port_no
port port_no
exit
cgw-service cgw_service_name
bind ipv4-address ipv4_address
associate egress-egtp_service egress-egtp_service_name
revocation enable
session-delete-delay timeout timeout_msecs
exit
samog-service samog_service_name
associate mrme-service mrme_service_name
assoicate cgw-service cgw_service_name
associate subscriber-map subscriber_map_name
exit
Important:
Configure the custom71 dictionary when Cisco WLC is used with PMIPv6 as the access-type.
Configuring the custom71 dictionary enables attributes like the UE’s permanent identity (NAI), subscribed APN,
network protocol (PMIPv6), and LMA address (CGW service’s bind address) to be sent in the Cisco Vendor-specific
attributes to WLC. The WLC uses this information to build the PMIPv6 PBU to the SaMOG gateway when the
network protocol (PMIPv6), and LMA address (CGW service’s bind address) to be sent in the Cisco Vendor-specific
attributes to WLC. The WLC uses this information to build the PMIPv6 PBU to the SaMOG gateway when the
aaa-
override
option is enabled on the Cisco WLC. These attributes are not sent when the custom70 dictionary is
configured.
Configuring the LTE Policy
The LTE Policy Configure the LTE policy by applying the example configuration below.
config
operator-policy policy-name
apn network-identifier apn_net_id apn-profile apn_profile_name
associate call-control-profile profile_id
exit
call-control-profile profile_name
accounting mode gtpp
authenticate context context_name aaa-group aaa_group_name