Cisco Cisco Packet Data Gateway (PDG) Merkblatt
APN Configuration Mode Commands
loadbalance-tunnel-peers ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
1329
loadbalance-tunnel-peers
Configures how tunnel-peers are selected for this APN.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
loadbalance-tunnel-peers { balanced | prioritized | random }
default loadbalance-tunnel-peers
default
Restores the loadbalance-tunnel-peers parameter to the default setting of random.
balanced
Tunnel-peer selection is made without regard to prioritization, but in a sequential order that balances the load
across the total number of peer nodes available. Default: Disabled
across the total number of peer nodes available. Default: Disabled
prioritized
Tunnel-peer selection is made based on the priority configured for the peer. Default: Disabled
random
Tunnel-peer selection is random in order. Default: Enabled
Usage
Use this command to configure the load-balancing algorithm that defines how the tunnel-peers are selected
by the APN when multiple peers are configured in the APN.
by the APN when multiple peers are configured in the APN.
Example
The following command sets the APN to connect to tunnel-peers in a sequential order:
load-balancing balanced