Cisco Cisco Packet Data Gateway (PDG) Merkblatt
Context Configuration Mode Commands I-M
▀ mpls ip
▄ Cisco ASR 5x00 Command Line Interface Reference
2468
mpls ip
Globally enables the Multiprotocol Label Switching (MPLS) forwarding of IPv4 packets along normally routed paths.
Product
GGSN
HA
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] mpls ip
no
Disables MPLS forwarding of IPv4 packets configured on the system.
no mpls ip
stops dynamic label
distribution on all the interfaces regardless of interface configuration.
Usage
Globally enables the MPLS forwarding of IPv4 packets along normally routed paths for the entire context.
It does not start label distribution over an interface until MPLS has been enabled for the interface as well.
Refer to the Ethernet Interface Configuration Mode Commands chapter for additional information.
It does not start label distribution over an interface until MPLS has been enabled for the interface as well.
Refer to the Ethernet Interface Configuration Mode Commands chapter for additional information.
Caution:
This feature is not enabled by default.
Example
Following command enables (but does not start) MPLS forwarding of IPv4 packets along normally routed
paths:
paths:
mpls ip