Cisco Cisco Packet Data Gateway (PDG) Merkblatt

 

▄  Cisco ASR 5x00 Command Line Interface Reference 

This command configures whether to continue or terminate calls when Diameter server or the OCS becomes 
unreachable. 

 

All 

 

Security Administrator, Administrator 

 

Exec > ACS Configuration > Credit Control Configuration 

active-charging service service_name > credit-control

 

Entering the above command sequence results in the following prompt: 

[local]host_name(config-dcca)# 

 

In 12.1 and earlier releases: 

servers-unreachable { initial-request { continue | terminate [ after-timer-expiry 
timeout_period ] } | update-request { continue | terminate [ after-quota-expiry | after-
timer-expiry timeout_period ] } } 

no servers-unreachable { initial-request | update-request } 

In 12.2 and later releases: 

servers-unreachable { behavior-triggers { initial-request | update-request } result-code 
{ any-error | result-code [ to end-result-code ] } | transport-failure [ response-timeout 
| tx-expiry ] | initial-request { continue [ { [ after-interim-time timeout_period ] [ 
after-interim-volume quota_value ] } server-retries retry_count ] | terminate [ { [ 
after-interim-time timeout_period ] [ after-interim-volume quota_value ] } server-retries 
retry_count | after-timer-expiry timeout_period ] } | update-request { continue [ { [ 
after-interim-time timeout_period ] [ after-interim-volume quota_value ] } server-retries 
retry_count ] | terminate [ { [ after-interim-time timeout_period ] [ after-interim-
volume quota_value ] } server-retries retry_count ] | after-quota-expiry | after-timer-
expiry timeout_period ] } } 

no servers-unreachable { initial-request | update-request } 

default servers-unreachable behavior-triggers { initial-request | update-request } 

 

Deletes the current servers-unreachable configuration. 
In 15.0 and later releases, to remove the error result code configuration, the 

 command syntax is 

servers-unreachable behavior-triggers { initial-request | update-request } 
result-code { any-error | result-code [ to end-result-code ] }

.