Cisco Cisco Packet Data Gateway (PDG) Merkblatt
Ethernet Port Configuration Mode Commands
srp virtual-mac-address ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
3549
srp virtual-mac-address
Configures the Standby Router Protocol (SRP) virtual MAC address for the port.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
srp virtual-mac-address MAC_Address
no srp virtual-mac-address
no
Disables the SRP virtual MAC addressing for Ethernet ports. The block of virtual MAC addresses is not
saved.
saved.
MAC_Address
Enables SRP virtual addressing for the specified MAC address.
Usage
The SRP virtual MAC address is applied to the port when the chassis is in SRP ACTIVE state. The default is
no srp virtual-mac-address
.
Important:
This command is not supported on all platforms.
Example
Use the following command to enable the SRP’s virtual MAC addressing:
srp virtual-mac-address MAC_Address