Cisco Cisco Packet Data Gateway (PDG) Merkblatt
Global Configuration Mode Commands (L-S)
▀ snmp notif-threshold
▄ Cisco ASR 5x00 Command Line Interface Reference
5250
snmp notif-threshold
Configures the number of SNMP notification that need to be generated for a given event before it is propagated to the
SNMP users.
SNMP users.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
snmp notif-threshold count [ low low_count ] [ period seconds ]
no snmp notif-threshold
no
Removes all SNMP notification thresholds. All notifications will be broadcast to SNMP users.
count
Default: 100
The traps creation rate will be monitored periodically (as configured by the
The traps creation rate will be monitored periodically (as configured by the
period
field). If the number of
traps created over one period cycle exceeds the count value configured, then the trap creation will be
disabled.
disabled.
count
must be an integer from 1 through 10000.
low
low_count
Default: 20
The traps creation rate will be monitored periodically (as configured by the
The traps creation rate will be monitored periodically (as configured by the
period
field). The trap creation
will be enabled again only if the number of trap creation drops below the
low_count
value configured.
Otherwise, trap creation remains disabled.
low_count
must be an integer from 1 through 10000.
period
seconds
Default: 300
Specifies the number of seconds of the monitoring window size before any subsequent notification may be
broadcast to users.
Specifies the number of seconds of the monitoring window size before any subsequent notification may be
broadcast to users.
seconds
must be an integer from 10 through 3600.
Usage
Set the notification threshold to avoid a flood of events which may be the result of a single failure or
maintenance activity.
maintenance activity.
Example