Cisco Cisco Packet Data Gateway (PDG) Merkblatt
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
▀ threshold route-service bgp-routes
▄ Cisco ASR 5x00 Command Line Interface Reference
5640
threshold route-service bgp-routes
Configures alarm or alert thresholds for the percentage of route services to BGP routes.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold route-service bgp-routes high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold rate percentage for BGP routes on the system that must be met or exceeded
within the polling interval to generate an alert or alarm.
Specifies the high threshold rate percentage for BGP routes on the system that must be met or exceeded
within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 100. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold rate percentage for BGP routes on the system that maintains a previously
generated alarm condition. If the number of setup failures falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
Specifies the low threshold rate percentage for BGP routes on the system that maintains a previously
generated alarm condition. If the number of setup failures falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 100. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to configure a threshold in percentage of maximum BGP routes allowed. If the percentage
of the number of BGP routes in a context (including all VRFs) reaches
of the number of BGP routes in a context (including all VRFs) reaches
high_thresh
, a notification is
generated. Optionally, if the threshold subsystem is configured in ‘alarm’ mode, a Threshold_Clear
notification is generated when the percentage of the number of BGP routes in a context (including all VRFs)
goes below
notification is generated when the percentage of the number of BGP routes in a context (including all VRFs)
goes below
low_thresh
. The maximum number of BGP routes is also sent by BGP task when getting the
statistics
Alerts or alarms are triggered for BGP routes based on the following rules:
Alerts or alarms are triggered for BGP routes based on the following rules:
Enter condition: Actual number of call setup failures is greater than the high threshold.
Clear condition: Actual number of call setup failures is less than the low threshold.