Cisco Cisco Packet Data Gateway (PDG) Merkblatt
ACS Rulebase Configuration Mode Commands
▀ cca quota
▄ Cisco ASR 5x00 Command Line Interface Reference
626
cca quota
This command allows you to configure various time- and threshold-based quotas in the Prepaid Credit Control Service
(Credit Control Application).
(Credit Control Application).
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
cca quota { holding-time holding_time content-id content_id | retry-time retry_time [
max-retries retries ] }
max-retries retries ] }
{ default | no } cca quota { holding-time content-id content_id | retry-time }
holding-time holding_time
Specifies the value for the Quota Holding Time (QHT). QHT is used with both time-based and volume-based
quotas. After
quotas. After
holding_time
seconds has passed without user traffic, the quota is reported back and the
charging stops until new traffic starts.
holding_time
must be an integer from 1 through 4000000000.
content-id content_id
Specifies the content ID (Rating group AVP) to use for the Quota holding time for the current rulebase.
content_id
is the content ID specified for credit control service in ACS.
In 12.1 and earlier releases,
content_id
must be an integer from 1 through 65535.
In 12.2 and later releases,
content_id
must be an integer from 1 through 2147483647.
retry-time retry_time [ max-retries retries ]
Specifies the retry time for the quota request, in seconds.
retry_time
must be an integer from 0 through 86400. To disable this assign 0.
Default: 60
This parameter defines the maximum frequency at which the Credit-Control Application (CCA) tries to
obtain quota for a subscriber passing traffic for a category with no/exhausted quota.
For a subscriber not passing traffic, the CCA will not try to obtain quota (except once at session start time, if
so configured). The quota request from the no quota state is sent in response to user packets only (never based
on a timer).
When subscriber hits a charging action that is a flow redirect, the operator can optionally specify that this
redirection shall clear the retry-time timer.
This parameter defines the maximum frequency at which the Credit-Control Application (CCA) tries to
obtain quota for a subscriber passing traffic for a category with no/exhausted quota.
For a subscriber not passing traffic, the CCA will not try to obtain quota (except once at session start time, if
so configured). The quota request from the no quota state is sent in response to user packets only (never based
on a timer).
When subscriber hits a charging action that is a flow redirect, the operator can optionally specify that this
redirection shall clear the retry-time timer.