Cisco Cisco Packet Data Gateway (PDG) Merkblatt

Seite von 8487
IuPS Service Configuration Mode Commands   
▀  loss-of-radio-coverage ranap-cause 
 
 
▄  Cisco ASR 5x00 Command Line Interface Reference 
6482 
   
loss-of-radio-coverage ranap-cause 
This command sets the detection cause included in the Iu Release message. This command is unique to releases 9.0 and 
higher. 
Product
 
SGSN 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > IuPS Service Configuration 
configure > context context_name > iups-service service_name
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-ctx-iups-service)# 
Syntax
 
loss-or-radio-coverage ranap-cause cause_number 
default loss-of-radio-coverage ranap-cause 
default
 
This keyword resets the configuration to the default cause ID number. 
ranap-cause cause_number
 
This number identifies the reason the SGSN has detected, from Iu Release messages, for the loss of radio 
coverage (LORC). This value is included in the IE messages the SGSN sends to either the GGSN or the 
GGSN and the peer SGSN to indicate LORC state. The range of reasons is a part of the set defined by 3GPP 
25413.  
cause_number
 : Must be an integer from 1 to 512. 
Default: 46 (MS/UE radio connection lost) 
Usage 
By defining a cause code, the SGSN knows to detect the LORC state of the mobile from Iu Release messages 
it receives for the subscriber. This configuration also instructs the SGSN to include the defined cause code for 
the LORC state in the IE portion of various messages sent to the GGSN and optionally the peer SGSN.  
This command is one of the two commands required to enable the SGSN to work with the GGSN and, 
optionally the peer SGSN, to implement the Overcharging Protection feature (see the SGSN Overview in the 
SGSN Administration Guide 
for feature details. The other command needed to implement the Overcharging 
Protection feature is the 
gtp private extension
 command explained in the SGSN APN Policy 
Configuration Mode chapter of the Command Line Interface Reference
Example
 
Use the following command to set the cause code to indicate that there are no radio resources available in the 
target cell, cause 
53
loss-or-radio-coverage ranap-cause 53