Cisco Cisco Packet Data Gateway (PDG) Merkblatt
MAG Service Configuration Mode Commands
▀ bind
▄ Cisco ASR 5x00 Command Line Interface Reference
6802
bind
Binds the service to a logical IP interface serving as the S2a (HSGW) or S5/S8 (S-GW) interface and specifies the
maximum number of subscribers that can access this service over the configured interface.
maximum number of subscribers that can access this service over the configured interface.
Product
HSGW
S-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MAG Service Configuration
configure > context context_name > mag-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mag-service)#
Syntax
bind address ip_address [ max-subscribers num ]
no bind address
no
Removes the interface binding from this service.
address ipv6_address
Specifies the IPv6 address of the interface configured as the S5/S8 interface.
ipv6_address
is specified in IPv6 colon-separated-hexadecimal notation.
max-subscribers num
Default: 1500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
num
must be an integer from 0 through 3000000.
Important:
The maximum number of subscribers supported depends on the installed license
key and the number of active packet processing cards in the system. A fully loaded system can
support 3,000,000 total subscribers. Refer to the
support 3,000,000 total subscribers. Refer to the
license key
command and the Usage section
(below) for additional information.
Usage
Associate the MAG service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an S2a or S5/S8 interface that provides the session connectivity to/from a P-GW. Only one
interface can be bound to a service. The interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
characteristics of an S2a or S5/S8 interface that provides the session connectivity to/from a P-GW. Only one
interface can be bound to a service. The interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.