Cisco Cisco Packet Data Gateway (PDG)

 

▄  VPC-VSM System Administration Guide, StarOS Release 19 

         { ip | ipv6 } access-group acl_list_name { in | out } [ preference ] 

         end 

Notes: 



 

The context name is the name of the ACL context containing the interface to which the ACL is to be applied. 



 

The ACL to be applied must be configured in the context specified by this command. 



 

Up to eight ACLs can be applied to a group provided that the number of rules configured within the ACL(s) does 

not exceed the 128-rule limit for the interface. 

This section describes how to verify the ACL configuration. 

In the Exec Mode, enter the following command: 

[local]host_name# show configuration context context_name 

context_name is the name of the context containing the interface to which the ACL(s) was/were applied. 

The output of this command displays the configuration of the entire context. Examine the output for the commands 
pertaining to interface configuration. The commands display the ACL(s) applied using this procedure. 

configure 

   context context_name 

      ip access-list acl_name 

         deny host ip_address 

         deny ip any host ip_address 

         exit 

      ip access-group access_group_name 

      service-redundancy-protocol 

      exit 

      interface interface_name 

         ip address ip_address/mask 

         exit 

      subscriber default 

      exit 

      aaa group default 

      exit