Cisco Cisco Packet Data Gateway (PDG)
VLANs
▀ VLANs and StarOS
▄ VPC-VSM System Administration Guide, StarOS Release 19
234
VLANs and StarOS
Creating VLAN Tags via StarOS
Use the following example to create VLANs on a port and bind them to pre-existing interfaces. For information on
creating interfaces, refer to the System Interfaces and Ports chapter.
creating interfaces, refer to the System Interfaces and Ports chapter.
config
port ethernet slot/port
no shutdown
vlan vlan_tag_ID
no shutdown
bind interface interface_name context_name
end
Notes:
Optional: Configure VLAN-subscriber associations. Refer to
more information.
Repeat this procedure as needed to configure additional VLANs for the port.
Refer to
information.
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Verifying the StarOS Port Configuration
Run the following command to verify the port configuration:
show port info slot/port
An example of this command’s output when at least one VLAN has been configured for the port is shown below:
Port: 1/11
Port Type : Virtual Ethernet
Role : Service Port
Description : (None Set)
Redundancy Mode : Port Mode
Redundant With : Non-redundant