Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren
Getting Started
▀ Configuring the Management Interface with a Second IP Address
▄ Cisco ASR 5500 System Administration Guide
44
Configuring the Management Interface with a Second IP
Address
If necessary, you can configure a second IP address on the MIO management interface.
Step 1
Enter the configuration mode by entering the following command at the prompt:
[local]host_name# configure
[local]host_name(config)#
[local]host_name(config)#
Step 2
Enter the following to enter the context configuration mode:
[local]host_name(config)# context local
[local]host-name(config-ctx)#
[local]host-name(config-ctx)#
Step 3
Enter the interface slot number and port number by entering the following command:
[local]host_name(config-ctx)# 5/1
[local]host_name(config-if-eth)#
[local]host_name(config-if-eth)#
Step 4
Enter the secondary IP address and subnet mask by entering the following command:
[local]host_name(config-if-eth)# { ip | ipv } address ipaddress subnet_mask
secondary
secondary
Step 5
Exit the configuration mode by entering the following command:
[local]host_name(config-if-eth)# end
Step 6
Confirm the interface ip addresses by entering the following command:
[local]host_name# show config context local
The CLI output should look similar to this example:
config
context local
interface interface_name
ip address ipaddress subnetmask
ip address ipaddress subnetmask secondary
#exit
context local
interface interface_name
ip address ipaddress subnetmask
ip address ipaddress subnetmask secondary
#exit
Step 7
Save your configuration as described in Verifying and Saving Your Configuration.