Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis
SAEGW Changes in Release 15.0
SAEGW Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
445
peer-map map_name [ -noconfirm ]
precedence priority match-criteria { all peer-profile-name profile_name | peer-
ip-address { ip_address | ip_address/mask } [ serving-plmnid mcc mcc mnc mnc ] peer-
profile-name profile_name | serving-plmnid mcc mcc mnc mnc [ peer-ip-address { ip_address
| ip_address/mask } ] peer-profile-name profile_name }
ip-address { ip_address | ip_address/mask } [ serving-plmnid mcc mcc mnc mnc ] peer-
profile-name profile_name | serving-plmnid mcc mcc mnc mnc [ peer-ip-address { ip_address
| ip_address/mask } ] peer-profile-name profile_name }
no precedence priority
end
Notes:
Precedence 1 has highest priority.
priority
must be an integer from 1 to 1024.
A maximum of 1024 precedence entries can be configured.
To map a peer to a profile when there is no specific criteria required, use the
all
keyword.
mcc
must be a three-digit number between 100 and 999.
mnc
must be a two- or three-digit number between 00 and 999.
show peer-profile
The following new command displays configuration of the specified peer profile.
show peer-profile { all | full { all | name profile_name } | name profile_name }
Modified SAEGW Commands
This section identifies SAEGW commands modified in release 15.0.
associate
The new keyword
peer-map
associates an LTE Policy peer map with a P-GW or S-GW service.
configure
context context_name
{ pgw-service | sgw-service } svc_name
associate peer-map map_name
no associate peer-map
end
associate
The new keyword
qci-qos-mapping
has been added to configure DSCP marking of the outer header of a GTP-U
tunnel packet based on a QCI table. DSCP marking shall be supported on a per APN basis.
configure