Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis

Seite von 678
SGSN Changes in Release 15.0   
▀  SGSN Enhancements for September 30, 2013 
 
 
▄  Cisco ASR 5x00 Release Change Reference 
510 
   
Handling of Delete Bearer Request During Inter-SGSN Handoff
 
Previous Behavior: Delete Bearer request during Inter SGSN Hand-off at the new SGSN was being queued and was 
processed once hand-off procedure was completed. 
New Behavior: Delete Bearer request during Inter SGSN hand-off at the new SGSN is rejected with cause “110 - 
Temporarily rejected due to hand over procedure in progress”. 
Impact: An increase in Delete Bearer Response with cause “110” is observed.  
Handling of Suspend-Resume Request from BSC in 2G S4 SM
 
Previous Behavior: Suspend, resume, radio status bad and ready were not handled from the BSC in a 2G S4 SM. 
New Behavior: The software has been enhanced so that Suspend, resume, radio status bad and ready are now handled 
from the BSC in a 2G S4 SM. 
Handling of Update PDP Request Modified
 
Previous Behavior:  The Update PDP request during new SGSN-SRNS procedure was rejected with “no resources 
available”. 
New Behavior: The Update PDP request during new SGSN-SRNS procedure is queued and taken up after the 
completion of DT RAU procedure.  
Inclusion or Exclusion of Common Flags IE in CPCQ/UPCQ
 
Previous Behavior: The 
gtpc
 command under SGTP Service Configuration Mode is used to include/exclude common 
flags IE in CPCQ/UPCQ. The dual PDP feature over-rides this CLI command, when the dual PDP feature is enabled, IE 
is always included in CPCQ. If NRSPCA is enabled, the common flags IE in CPCQ are sent even if it is disabled in the 
SGTP Service Configuration.  
New Behavior: Inclusion or exclusion of common flags in CPCQ/UPCQ is decided based on the following 
configurations: 
 
Common flags will be included if any of the following features are enabled, even if inclusion of common flags is 
disabled by the 
gtpc
 command in the SGTP Service Configuration Mode: 
 
Dual PDP feature 
 
NRSPCA feature 
 
If none of the above mentioned features are enabled, common flags are included or excluded based on the 
configuration enabled through the 
gtpc
 command in the SGTP Service Configuration Mode.  
Increased SCTP Associations per Peer RNC
 
Previous Behavior:  The maximum number of SCTP associations the SGSN supported per peer RNC was 4. 
New Behavior:  The maximum number of SCTP associations the SGSN supports per peer RNC is now 12; enabling the 
customer to configure more SCTP connections per peer. The increase in the number of SCTP connections is 
proportional to the increase in the PSP instances inside the peer server, as indicated in the Enhancing Link Management 
Mechanisms
 feature change description.  
Increasing Number of SS7 Peers Connected per SS7RD