Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis

Seite von 678
  SGSN Changes in Release 15.0 
SGSN Enhancements for September 30, 2013  ▀   
 
Cisco ASR 5x00 Release Change Reference  ▄  
 
   
517 
gprs-mocn
 
The new 
gprs-mocn
 command, in the SGSN-Global configuration mode, enables network sharing for GPRS multi-
operator core network (2G MOCN): 
config 
   sgsn-global 
      gprs-mocn 
      no gprs-mocn 
      end 
Note:  
 
When 
no
 is used with this command, the configuration reverts to the default status and GPRS MOCN is 
disabled. 
For additional information, refer to the 2G SGSN Multi-Operator Core Network chapter in the Serving GPRS Support 
Node Administration Guide
 
inter-rnc-procedures source-rnc-as-target
 
A new command has been added to Iups Service Configuration Mode to allow operators the ability to enable SRNS 
relocation for those scenarios where the source RNC is behaving as the target RNC. The default behavior is to disable 
SRNS relocation in those scenarios. 
config 
   context context_name 
      iups-service iups_service_name 
         inter-rnc-procedures source-rnc-as-target  
         no inter-rnc-procedures source-rnc-as-target  
         end 
Note: 
 
no
 disables the ability of the SGSN to process SRNS relocation when the source RNC is behaving as the target 
RNC. 
network-sharing cs-ps-coordination
 
The 
network-sharing cs-ps-coordination
 enables or disables the cs-ps coordination check for 
homer
 or 
roamer
. It is also used to set the failure code that will be sent while the SGSN is requesting the BSC to provide CS-PS 
coordination. 
The operator should configure cs-ps-coordination checking explicitly for homer or roamer subscribers and for the 
failure-code to be sent when the SGSN asks the BSC to perform CS-PS coordination. 
config