Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis
SGSN Changes in Release 15.0
SGSN Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
525
config
context <context_name>
iups-service <iups_service_name>
rnc id <rnc_id>
[default | no ] ranap paging-cause-ie mme-signalling <paging_cause_value >
end
Where:
The command
ranap paging-cause-ie mme-signalling < paging_cause_value >
is used to set the
Paging Cause IE value for paging from MME due to Circuit Switch Fallback (CSFB). Listed below are the
paging cause values which can be set:
paging cause values which can be set:
0 - Terminating conversational call
1 - Terminating streaming call
2 - Terminating interactive call
3 - Terminating background call
4 - Terminating low priority signaling
5 - Terminating high priority signaling
The default command resets the specific parameters value to default. In this case it is set to “5 - Terminating high
priority signaling”.
The no form of the command suppresses the Paging Cause IE so that it is not included in responses to Paging
Requests.
routing-context
A new keyword
m3ua-data
is included in the
routing-context
command. This keyword controls the insertion of
routing context in outbound M3UA data messages. The default behavior is to insert routing context in management
messages and suppress routing context in data messages.
messages and suppress routing context in data messages.
config
ss7-routing-domain <index_name>
peer-server<peer_server_id>
psp<psp_instance>
routing-context { discard-inbound | process-inbound | m3ua-data
{ insert-outbound | suppress-outbound } }
{ insert-outbound | suppress-outbound } }
end
show gtpu
There are two new keywords related to displaying information per local addresses for GTPU services.