Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis
AAA Changes in Release 15.0
AAA Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
63
Important:
Rate Limiting Function (RLF) is a license-controlled feature. A valid feature license must be
installed prior to configuring this feature. Contact your Cisco account representative for more information.
configure
rlf-template rlf_template_name
msg-rate tps_value burst-size size [ -noconfirm ]
end
peer-backoff-timer
Applicable Product(s): GGSN, HA, P-GW
This command is used to configure a peer backoff timer which will be started when the server (primary or secondary
PCRF) is busy. That is, the backoff-timer is started when the result code 3004 – DIAMETER_TOO_BUSY is received
from PCRF. No CCR-I messages will be sent to the server until this timer expires.
PCRF) is busy. That is, the backoff-timer is started when the result code 3004 – DIAMETER_TOO_BUSY is received
from PCRF. No CCR-I messages will be sent to the server until this timer expires.
configure
context context_name
diameter endpoint endpoint_name
peer-backoff-timer timeout [ send-app-level-term-req ]
{ default | no } peer-backoff-timer
end
ran bandwidth optimize
This command is used to enable optimized calculation of [MBR, GBR] when a subscriber (voice) call is put on hold in
case of VoLTE.
case of VoLTE.
configure
require active-charging
active-charging service service_name
rulebase rulebase_name
[ default | no ] ran-bandwidth optimize
end
During session setup, when a CCA-I is received, and if
ran bandwidth optimize
is configured for the associated
rulebase, the system will aggregate [MBR, GBR] values of only the rules which have flow-status='ENABLED'. This
information will subsequently be sent to UE.
information will subsequently be sent to UE.
By default, this CLI will be disabled. Any change in this configuration will not affect existing calls on the system.
Optimized bandwidth calculation will be done only for the new calls established after enabling this CLI command.
Optimized bandwidth calculation will be done only for the new calls established after enabling this CLI command.