Cisco Cisco Aironet 1260 Access Point
-xix
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Preface
Audience
This guide is for the networking professional who installs and manages Cisco Aironet Access Points in
Autonomous mode. To use this guide, you should have experience working with the Cisco IOS software
and be familiar with the concepts and terminology of wireless local area networks.
Autonomous mode. To use this guide, you should have experience working with the Cisco IOS software
and be familiar with the concepts and terminology of wireless local area networks.
The guide covers Cisco IOS Releases 15.2(4)JB3a. The following access point platforms are supported:
•
AP 702
•
AP 802
•
AP 1040
•
AP 1140
•
AP 1260
•
AP 1530
•
AP 1550
•
AP 1600
•
AP 2600
•
AP 3500
•
AP 3600
•
AP 3700 (Site survey only)
For Cisco Aironet 1530 Series access points alone, you are required to load the Cisco IOS version
15.2(4)JB3b. This IOS version applies only to Cisco Aironet 1530 Series access points.
15.2(4)JB3b. This IOS version applies only to Cisco Aironet 1530 Series access points.
Note
This guide does not cover lightweight access points. Configuration for these devices can be found in the
appropriate installation and configuration guides on Cisco.com.
appropriate installation and configuration guides on Cisco.com.
Note
You can install Cisco IOS Release 15.2(4)JB3a on Cisco Aironet 3700 Series access points to perform
site surveys. The AP3700 series access points are supported only in site survey mode. This release runs
on these access points with limited functionality. You can manually adjust the following settings on such
site-survey access points:
site surveys. The AP3700 series access points are supported only in site survey mode. This release runs
on these access points with limited functionality. You can manually adjust the following settings on such
site-survey access points:
– Channels on each radio
– Transmission power on each radio