Cisco Cisco Configuration Engine 3.5.5

CSCul96579

Symptom: User is unable to configure cns event with source interface during Configuration Engine 
setup.

Conditions: This problem occurs during the setup of Cisco Configuration Engine. when the setup 
prompt to enter cns command as shown below: 

 "Enter CNS Event command: cns event bgl-dt-CE3 keepalive 120 2 reconnect 10

The user is not able to provide “cns event bgl-dt-ce3 source gigabitEthernet0/0 keepalive 120 2 reconnect 
10”

Workaround: Configure route’s such as not to use source interface on the cns commands.

CSCuo59650

Symptom: FTP and TFTP does not work.

Conditions: This condition occurs when Reloading xinetd ...

/etc/rc.d/init.d/xinetd reload

Reloading configuration: ^[[60G[^[[0;31mFAILED^[[0;39m]^M.

Workaround: Execute etc/rc.d/init.d/xinetd restart from the server command line prompt to start the 
xinetd.

CSCur33032

Symptom: Installed CE using ce_install.sh script. Verified the user called setup exists in /etc/password 
file.

Conditions: This condition occurs when the Cisco Configuration Engine Software, 3.5.4 is installed in 

RHEL6 (64-bit SMP, kernel 2.6, and SELinux disabled)

Workaround: Deleted the setup user using userdel command in $CISCO_CE_HOME/bin directory and 
Run ./setup script and perform the setup.

CSCur76511

Symptom: While trying to update httpd, update is not happening due to the unsatisfied dependencies 
with respect to the packages.

Unset the $LD_LIBRARY_PATH and execute :  rpm –Va from server command line prompt.

Conditions: Cisco Configuration Engine Software, 3.5.4 is installed in RHEL6 (64-bit SMP, kernel 2.6, 
and SELinux disabled).

Workaround: There is no workaround.