Cisco Cisco 1 GHz GainStar Node Installationsanleitung
2-2
Installation and Configuration
4042027 Rev A
Before You Begin
The procedures in this chapter assume that you have completed the following:
Prepared the installation site
Located the coaxial cable, with or without pin-type coaxial connectors mounted on
the cable
the cable
Required Tools
Before you start, make sure that you have the following tools:
Torque wrench with a 1/2-inch socket
Flat-blade screwdriver
Heavy-duty wire cutters or snips
Torque wrench set
Torque Specifications
The following table gives the torque specifications for the Node.
Fastener
Torque Specification
Illustration
Seizure nut
2.0 Nm to 2.8 Nm
Housing Retainer Screws
1.5 Nm to 1.8 Nm
Housing closure bolts
6.8 Nm to 9.0 Nm
Housing plugs test point port
plugs
plugs
6.8 Nm to 9.0 Nm
RF PG11 to 5/8” adapter
12.0 Nm to 16.0 Nm
Optical PG11 to 5/8”adapter
12.0 Nm to 16.0 Nm
Strand clamp mounting bracket
bolts
bolts
6.8 Nm to 9.0 Nm
RF F-Cable Connector
Per manufacturer
instructions
instructions
Hardline Cable Connector
Per manufacturer
instructions
instructions
Continued on next page