Cisco PowerKEY CableCARD Module 801 Technische Referenzen

4 

 

4020737 Rev C 

 

This section lists the prerequisites for executing the modCCardStagingLimit script 
and provides other information you should consider before attempting to obtain and 
execute the script. 

The modCCardStagingLimit script supports the following system releases: 

 

SR 2.2/3.2 SP 5 and later 

 

SR 2.5/3.5/4.0 SP 3 (Patch 3) and later  

 

SR 2.7/3.7/4.2 and later 

Important! SR 2.2/3.2 SP 5 does not support the combo-binding staging method. For 
a list of the staging methods supported in each release, refer to Separable Security 
Host Staging Guide.  

You do not need to execute the script during a maintenance window, as a restart of 
the system is not required for changes to take effect.  However, for the system to 
implement changes that the script makes, you must restart the CableCARD Server 
process. While the CableCARD Server process stops and restarts, no binding can 
occur. To ensure the best results, we recommend that you execute the script at a time 
when your system does not experience heavy revenue-generating activity.  

Allow about 30 minutes to perform the following tasks, which are required to 
execute the script:  
1  Obtain the script from the Cisco FTP server. 
2  Change the staging limit to 1500 binding operations per staging period by 

executing the script on the DNCS. 

3  Restart the CableCARD Server process and wait one minute after restarting this 

process to have the system implement this change. 

Important! You must restart the CableCARD Server process and then allow one 
minute to elapse to enable the system to bind up to 1500 CableCARD modules 
and hosts. Failing to restart the CableCARD Server process after executing the 
script results in no change to the staging capacity.