Cisco Cisco D9824 Advanced Multi Decryption Receiver Installationsanleitung
Chapter 4 Front Panel Operation
80
OL-29015-01
Video
Menu Item
Description
Parameters
PV Format
Sets the primary video output format for
local decoding.
local decoding.
Auto, SD, HD 720p, or HD
1080i
1080i
PV Output
Indicates the actual output video format.
This value is read-only.
This value is read-only.
SD, HD 720p, or HD 1080i
Stream
Indicates the video format of the input
video stream. This value is read-only.
video stream. This value is read-only.
SD Format
Selects the standard definition output
format to use on the primary video if the
PV Output is set to SD.
format to use on the primary video if the
PV Output is set to SD.
Auto, NTSC, PAL-N (AR),
PAL-M or PAL-B/G/I/D. Use
NTSC for 525-line systems and
PAL-B/G/I/D for 625-line
systems.
PAL-M or PAL-B/G/I/D. Use
NTSC for 525-line systems and
PAL-B/G/I/D for 625-line
systems.
SD Output
Indicates the actual standard definition
format of the primary video output if the
PV Output is set to SD.
format of the primary video output if the
PV Output is set to SD.
NTSC, PAL-N (AR), PAL-M or
PAL-B/G/I/D
PAL-B/G/I/D
Bitrate
Indicates the bit rate of the input video
stream, in Mbps.
stream, in Mbps.
Tri-Synch
Select whether to use component Tri-
Synchronization.
Synchronization.
Enabled or Disabled
Alarm Video Cutoff Sets whether the video output is cut off if
any enabled alarm is active on the receiver.
When video is cut off, there will be no
horizontal or vertical synchronization on
the output. This is useful for downstream
redundancy switching by detecting a loss
of video signal.
When video is cut off, there will be no
horizontal or vertical synchronization on
the output. This is useful for downstream
redundancy switching by detecting a loss
of video signal.
Note: This same function also exists under
Setup: Alarm/Warning.
Setup: Alarm/Warning.
Enable or Disable.
The default is Disable.
OSD Messages
Sets whether alarms and warnings are to
be displayed on the on-screen display (e.g.,
TV monitor).
be displayed on the on-screen display (e.g.,
TV monitor).
Enable or Disable
TV A/R
Select the standard definition aspect ratio
of your TV monitor.
of your TV monitor.
4:3 or 16:9
Convert
Select the conversion method that the
receiver will perform on the incoming
signal for the picture to be displayed
correctly on your TV based on the TV A/R
setting.
receiver will perform on the incoming
signal for the picture to be displayed
correctly on your TV based on the TV A/R
setting.
None, Auto, Auto AFD, 16:9
L/B, 4:3 P/B, 14:9, 4:3 CCO,
16:9 SCALE. The default is
Auto. For more information, see
Aspect Ratio Conversions (on
page 81).
L/B, 4:3 P/B, 14:9, 4:3 CCO,
16:9 SCALE. The default is
Auto. For more information, see
Aspect Ratio Conversions (on
page 81).
Stream
Indicates the aspect ratio of the incoming
video stream. This is read-only.
video stream. This is read-only.
4:3 or 16:9