Cisco Cisco Digital Service Access Node (DSAN) 8211 Installationsanleitung
Installing and Removing the RF Module
OL-29938-01
57
Important: The cover should lie completely flat on the RF module chassis.
4 Connect all interface cables to the RF module.
To Remove the RF Module
Complete the following steps to remove the DSAN 8211 RF module.
1 Open the node housing. Refer to To Open the Housing (on page 44).
2 Disconnect all interface cables from the RF module.
1 Open the node housing. Refer to To Open the Housing (on page 44).
2 Disconnect all interface cables from the RF module.
Important: When removing RF cables from the digital board, be sure to activate
the unlocking tab as shown in the following illustration.
the unlocking tab as shown in the following illustration.
3 Using a screwdriver, loosen the six numbered retaining screws on the module.
4 With a firm grip, pull up on the RF module and remove it from the housing base.
4 With a firm grip, pull up on the RF module and remove it from the housing base.
Note: The RF module has notches that can be used as pry points if necessary to
remove it from the housing base.
remove it from the housing base.
5 Close the node housing. Refer to To Close the Housing (on page 44).