Cisco Headend System Release 2.5
Chapter 4 Post-Upgrade Procedures
68
4004148 Rev C
Configure SAM Timers
Introduction
After you complete the installation process, the Update Timer and Schedule Timer
fields on the SAM Configuration window need to be set at specific values. These
values ensure that channel maps and the database have sufficient time to update.
The instructions in this section guide you through the necessary steps.
fields on the SAM Configuration window need to be set at specific values. These
values ensure that channel maps and the database have sufficient time to update.
The instructions in this section guide you through the necessary steps.
Important: Skip this procedure if your site does not support SARA.
Configuring the SAM Timers
Follow these instructions to set the Update Timer and Schedule Timer fields on the
SAM Configuration window.
1 From the DNCS Administrative Console, select the Application Interface
SAM Configuration window.
1 From the DNCS Administrative Console, select the Application Interface
Modules tab and then click SAM Config. The SAM Configuration window
opens.
opens.
2 Follow these instructions to configure the SAM Configuration window.
a In the Update Timer field, type 600.
b In the Schedule Timer field, type 1200.
b In the Schedule Timer field, type 1200.
3 Click Save.