Cisco Headend System Release 2.5 Installationsanleitung
Network Management Interface Software Checklist
78-745262-01Rev C
5
Network Management Interface Software Checklist
Answer the questions in this section to ensure that your DNCS meets the minimum
requirements to support the NMI software.
Important: If you respond No to any of these questions, you must correct the
Important: If you respond No to any of these questions, you must correct the
situation before you can install Alarm Manager software.
Requirement
Yes
No
Follow these instructions to determine the current DNCS
software version supported by your system.
1
From an xterm window, type pkginfo -l SAIdncs and
then press Enter.
Note: The "l" is a lowercase L.
Result: The system displays the version of software
Note: The "l" is a lowercase L.
Result: The system displays the version of software
loaded on the DNCS.
2
Record the DNCS software version here: ___________
3
Does the DNCS support SR 2.2 or SR 3.2 Service Pack 2
or later, system software?
Note: If you have not already installed SR 2.2 or SR 3.2
Service Pack 2 or later software, you must do so before
installing the Alarm Manager software.
Follow these instructions to determine whether port 5161
on the DNCS is available for the NMI software to receive
Simple Network Management Protocol (SNMP) requests.
1
From an xterm window, type grep 5161 /etc/services
and then press Enter.
2
Is port 5161 available for the NMI software to receive
SNMP requests?
Notes:
If port 5161 does not appear in the output of the
command, then the port is available for use to receive
SNMP requests.
If an entry for this port does appear in the output, the
port is available for use to receive SNMP requests as
long as the comment portion of the entry indicates
something similar to "Used by NMI".