Cisco Headend Digital Broadband Delivery System Betriebsanweisung
13-10
Transmit the ModifyDhctConfiguration Transaction With the modDhctCfg Utility 749640 Rev D
How to Use the modDhctCfg Utility
Introduction
The instructions and examples in this section describe how to use the modDhctCfg
utility. This section covers those options that Cisco engineers think system operators
are most likely to use. Refer to Options Available With the modDhctCfg Utility,
earlier in this chapter, for examples showing how to use the various supported
options.
Running the modDhctCfg Utility
Refer to the following procedures to run the modDhctCfg utility.
Note: The transaction that the utility sends is the same ModifyDhctConfiguration
Note: The transaction that the utility sends is the same ModifyDhctConfiguration
transaction that was sent to the DHCT(s) the last time the DHCTs received a
ModifyDhctConfiguration transaction. The utility simply retrieves the data from the
database and re-transmits it.
Sending the ModifyDhctConfiguration Transaction to a Single DHCT
Follow these instructions to send the ModifyDhctConfiguration transaction to a
Sending the ModifyDhctConfiguration Transaction to a Single DHCT
Follow these instructions to send the ModifyDhctConfiguration transaction to a
single DHCT.
1.
If necessary, open an xterm window on the DNCS.
2.
Type modDhctCfg [DHCT MAC address] and then press Enter.
Note: Substitute the MAC address of the DHCT for [DHCT MAC address].
Example: modDhctCfg 00:02:DE:4A:11:92
Result: The system sends the ModifyDhctConfiguration transaction to the
Note: Substitute the MAC address of the DHCT for [DHCT MAC address].
Example: modDhctCfg 00:02:DE:4A:11:92
Result: The system sends the ModifyDhctConfiguration transaction to the
specified DHCT.
Sending the ModifyDhctConfiguration Transaction to a List of DHCTs
Follow these instructions to send the ModifyDhctConfiguration transaction to a list
Follow these instructions to send the ModifyDhctConfiguration transaction to a list
of DHCTs.
1.
If necessary, open an xterm window on the DNCS.
2.
type modDhctCfg [file name] and then press Enter.
Note: Substitute the name of the file you prepared for [file name].
Example: modDhctCfg modDhctCfg-in_11.13.03
Result: The system sends the ModifyDhctConfiguration transaction to all the
Note: Substitute the name of the file you prepared for [file name].
Example: modDhctCfg modDhctCfg-in_11.13.03
Result: The system sends the ModifyDhctConfiguration transaction to all the
DHCTs represented in the file.
Continued on next page