Cisco Headend System Release 2.7 Betriebsanweisung
Chapter 4 Restoration Procedures
46
4013779 Rev C
5 Have you just restored the file system of a Sun Fire V240 or V245 Application
Server?
If yes, type /cdrom/cdrom0/s3/backup_restore/mirrState -a and then press
Enter. The system displays the following message:
WARNING!
WARNING!
Proceeding beyond this point will Attach all Controller 2 submirrors.
Are you certain you want to proceed?
If no, go to step 7.
6 Type y and then press Enter. The system enables the disk mirroring functions on
the Application Server.
Note: Depending upon your system configuration, it may take up to an hour for
Note: Depending upon your system configuration, it may take up to an hour for
all of the data to become mirrored.
7 Type eject cdrom and then press Enter. The system ejects the CD.
8 Click the right mouse button on the Application Server and select Log Out. The
8 Click the right mouse button on the Application Server and select Log Out. The
root user logs off and the CDE window returns.
9 Log on to the CDE window as dncs user.
10 Type boot and press Enter at the ok prompt on the Application Server; then, log
10 Type boot and press Enter at the ok prompt on the Application Server; then, log
on to the Application Server as dncs user.
11 Follow the procedures in
Restarting System Components (on page 63) to restart
Spectrum, the DNCS, and the Application Server.
Restoring the Application Server File System from a Remote Host Computer
Complete the following steps to restore the Application Server file system from a
tape in another computer—commonly referred to as a remote host computer.
Example: Use this procedure, for instance, if you are restoring the Application
Example: Use this procedure, for instance, if you are restoring the Application
Server file system from a tape in the DNCS.
Note: If you have correctly followed the directions in this chapter, you should be
Note: If you have correctly followed the directions in this chapter, you should be
logged on to an xterm window as root user.
1 Type /tmp/cdrom/backup_restore/restoreFileSystems -v -r [hostname or IP
1 Type /tmp/cdrom/backup_restore/restoreFileSystems -v -r [hostname or IP
address]:[tape device] and then press Enter. The system restores the Application
Server file system and displays a message when the restoration is complete.
Notes:
Notes:
Substitute the hostname or IP address of the remotely located computer for
[hostname or IP address].
Type the command on one line.
Example:
/tmp/cdrom/backup_restore/restoreFileSystems -v -r 192.168.44.71:/dev/rmt/0h
2 When the restoration is complete, eject the tape and store it in a safe place.