Cisco Headend System Release 3.2 Installationsanleitung
Prepare the DNCS for Common Download
4017307 Rev C
13
3 Press the Enter key to display the CAQAM or MQAM prompt.
If the CAQAM> prompt appears, type pidmode 1 and press Enter to place
the CAQAM ASI card receiving stream in pass through mode.
If the MQAM> prompt appears, type pidmode 1 0x0 999 and press Enter to
place the MQAM ASI card receiving stream in pass through mode.
Notes:
If you need to take the CAQAM or MQAM out of pass-through mode, type
pidmode 0 and press Enter in this step.
To check the status of the CAQAM or MQAM, type pidmode and press
Enter in this step.
4 Reboot the QAM modulator for the changes to take effect.
5 Activate a ProComm or HyperTerminal window again and type pidmode to
5 Activate a ProComm or HyperTerminal window again and type pidmode to
verify that pass-through is enabled.