Cisco Headend System Release 2.7 Wartungshandbuch
Decide Binding Type
4024836 Rev D
23
Setting Up the DNCS for Autobinding
1 On the DNCS Administrative Console, select the Home Element Provisioning
1 On the DNCS Administrative Console, select the Home Element Provisioning
tab.
2 Click CableCARD. The CableCARD Summary screen opens showing the
CableCARD filter.
3 Click Server Configuration. The Server Configuration screen opens.
4 Enter the following information into the appropriate fields within the Configure
CableCARD Server screen:
IP Address—Enter the IP address of the server that is running the
CableCARD Server. In most cases, the CableCARD Server runs on the DNCS.
If this is the case for your system, type 10.253.0.1 in this field.
Important: If you do not use the default IP address for your CableCARD
Important: If you do not use the default IP address for your CableCARD
server, check your network map, the /etc/hosts file for the dncsatm entry, or
with your network administrator for the correct IP address.
Note: If you do not want to use autobinding for CableCARD modules, enter
Note: If you do not want to use autobinding for CableCARD modules, enter
0.0.0.0 in this field.
Port Number—Enter the port number on the DNCS that the CableCARD
server will monitor for incoming CableCARD module requests. The port
number is 13830.
Note: If you do not want to use autobinding for CableCARD modules, enter
Note: If you do not want to use autobinding for CableCARD modules, enter
0 in this field.
Authorization Time-out Period—Enter the length of time (in hours) the
Host-CableCARD pair is kept in the file on the BFS. We recommend that you
enter 2 in this field.