Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installationsanleitung
Chapter 5 Advanced Operations
376
4039132 Rev B
a Create the QAM on the USRM as follows:
i Navigate to the Platform.ConfigManager.Resource Create page, enter a
unique resource name in the CreateName field associated with the device
type being created, and then click Commit Changes. Do this for all
resources to be added.
type being created, and then click Commit Changes. Do this for all
resources to be added.
ii Refresh the tree by clicking either the top-level USRM name or the web
browser refresh button. This will cause the newly-added resources to
show up in the tree in the ResourceManager.QAMs section.
show up in the tree in the ResourceManager.QAMs section.
b Read the QAM settings (Cisco QAMs only) as follows:
i Navigate to the ResourceManager.QAMs.QAM xyz.Chassis page (where
QAM xyz is an individual QAM named "xyz").
ii Enter the IP Address of the QAM management port in the CtrlIpAddress
field, and then click Commit Changes.
This will cause the USRM to read the QAM settings (frequency, tsid, etc.)
via SNMP and place the information in the USRM tables.
This will cause the USRM to read the QAM settings (frequency, tsid, etc.)
via SNMP and place the information in the USRM tables.
iii Verify the QAM settings by navigating to the QAM Channels page.
Important: Verify that the Service Type (SDV, VOD) and Admin States
are set properly.
are set properly.
c Assign Service Groups as follows:
i Navigate to the ResourceManager.QAMs.QAM xyz.Output Ports page
(where QAM xyz is an individual QAM named "xyz").
ii Enter the Service Group ID associated with each port, verify that the
Admin State is set to InService, and then click Commit Changes.
iii Verify that sessions are created:
1. Monitor the EventLog tail.
2. Resource Manager.QAMs.QAM xyz.Sessions page for video and MCP
sessions.
3. Verify that mini-carousels are created on the QAM by going to the
Applications.McmisServer.MCP Sessions page.
4. For a graphical view, go to the Applications.SdvSm.Service Groups
Bandwidth page and click on QamGraphic Display for the desired
Service Group.
2. Resource Manager.QAMs.QAM xyz.Sessions page for video and MCP
sessions.
3. Verify that mini-carousels are created on the QAM by going to the
Applications.McmisServer.MCP Sessions page.
4. For a graphical view, go to the Applications.SdvSm.Service Groups
Bandwidth page and click on QamGraphic Display for the desired
Service Group.
9 Update Zone configuration information (for sites using zones).
Note: This step is only for sites using zones. For a site creating a zone from
scratch, please refer to a separate document.
a Navigate to the Applications.SdvSm.Service Groups Config page, enter the
scratch, please refer to a separate document.
a Navigate to the Applications.SdvSm.Service Groups Config page, enter the
zone for each service group, and then click Commit Changes.