Cisco Compact Mini Amp Models 93191 & 93198 862 MHz with 42 54 MHz Split Installationsanleitung
2-26
Installing and Configuring the GainMaker Line Extender
593057 Rev E
Installing Accessories,
Continued
3.
Install the surge protector in the surge protector slot. Refer to the illustration
below.
below.
T7350
1.5
1.5
1.5
1.5
1.5
Surge
Protector
Protector
Notes:
• Be sure all the pins on the surge protector bottom align with the pin holes
• Be sure all the pins on the surge protector bottom align with the pin holes
in the surge protector slot, allowing the surge protector to install flat
against the amplifier module.
against the amplifier module.
• Make sure the components face the outside of the station (see the diagram
above for proper positioning). Heat shrink tubing has been added to
prevent shorting.
prevent shorting.
4.
Replace the amplifier cover and tighten the amplifier cover screws from
10 in-lb to 12 in-lb (1.12 Nm to 1.35 Nm).
10 in-lb to 12 in-lb (1.12 Nm to 1.35 Nm).
Important: Reinstall the amplifier module cover properly or RF signal
degradation may result.
degradation may result.
5.
Install other options or accessories as desired, or proceed to Section C,
Installing the Line Extender Amplifier Module.
Installing the Line Extender Amplifier Module.
.