Cisco Compact Mini Amp Models 93191 & 93198 862 MHz with 42 54 MHz Split Installationsanleitung
744491 Rev B
Installing and Configuring the GainMaker Node
2-13
Attaching the Coaxial Connectors
Trimming the Center Conductor
The GainMaker Node requires pin-type connectors for all RF connections.
Standard pin connectors, with pins extending 1.5 in. to 1.6 in. (3.8 cm to 4.1 cm) from
the connector shoulder, require no trimming. You must trim longer pins before
inserting them into the housing.
the connector shoulder, require no trimming. You must trim longer pins before
inserting them into the housing.
To trim long pins, follow the steps in the table below.
1. Place the connector above the entry port so that it lines up with its installed
position.
position.
2. If the center conductor pin extends past the STRIP line on the housing, trim the
pin flush to the STRIP line. See the section entitled Center Conductor Trim Length.
pin flush to the STRIP line. See the section entitled Center Conductor Trim Length.
Center Conductor Trim Length
The following diagram shows a visual guide of the center conductor trim length.
Continued on next page