Cisco Cisco StadiumVision Mobile Wartungshandbuch
© 2011 Cisco Systems, Inc. All rights reserved.
Page 57 of 94
status is updated to match the TV. The status log is then dispatched to SV Director
containing the TV On/Off status.
containing the TV On/Off status.
The Status Refresh from the dashboard only gets the
DMP‟s view of the TV‟s on/off
status and doesn‟t actually trigger the above mechanism. If the power to the TV is
toggled without the
toggled without the
DMP‟s knowledge, for example using the TV‟s IR remote, the
results in the dashboard could take up to 5 minutes or so before it is updated. If the
TV status is altered and the DMP is aware of the change, for example sending a TV
on command from the Management Dashboard, this status is available immediately.
TV status is altered and the DMP is aware of the change, for example sending a TV
on command from the Management Dashboard, this status is available immediately.
If not already configured in the Display Specifications for the particular TV of
interest, configure the dmp.displayPwrQuery and dmp.displayPwrOnResponse
strings in the Display Specification screen as shown above.
interest, configure the dmp.displayPwrQuery and dmp.displayPwrOnResponse
strings in the Display Specification screen as shown above.
Viewing the Workflow Status
There are indicators in the SV Director Management Dashboard, on the TV, and on
the Control Panel that provide you information on the DMP auto provisioning status.
the Control Panel that provide you information on the DMP auto provisioning status.
Viewing the Workflow Status in the Dashboard
Once a DMP has auto registered, you can view the auto provisioning status through
the Management Dashboard. The Provision DMP workflow progress is displayed in
the Management Dashboard. The Provision DMP workflow progress is displayed in