Cisco Cisco Prisma II EDR Receiver Installationsanleitung
Chapter 3 Operation using ICIM
72
To Restart the ICIM by Removing the ICIM
1 Unscrew the captive screw near the top right-hand corner of the ICIM.
2 Unlock the top and bottom ejector levers near the left-hand side of the ICIM.
3 Pull the ejector levers out and away from the front panel to disconnect the ICIM
2 Unlock the top and bottom ejector levers near the left-hand side of the ICIM.
3 Pull the ejector levers out and away from the front panel to disconnect the ICIM
from the chassis backplane connector.
4 Pull the ICIM at least 1.5 inches (3.81 cm) out from the front of the chassis to
ensure that it is fully separated from the chassis backplane connector.
5 Reinsert the ICIM into the chassis until the ejector levers insert into their
respective slots in the chassis.
6 Push the ejector levers in and flat against the ICIM front panel to reconnect the
ICIM to the backplane connector until the ejector levers lock in place.
7 Screw in the captive screw to secure the ICIM in the chassis.