Cisco Prisma II 1310 nm HDTx Transmitters Installationsanleitung
Chapter 2 Module Installation
22
78-4021716-01 Rev C
2 Align the ridges on the top and bottom of the module with the module guide
slots located on the chassis.
3 Gently slide the module into the chassis until its power and communications
connections join connectors on the midplane bus. Do not force the module into the
chassis. If properly aligned, it should slide in with minimal force.
4 Tighten the screw at the top of the module to secure it in the chassis. Use a 3/8-
in. flat-blade screwdriver to secure. Do not over-tighten.
5 Fill any unused chassis slots with module blanks to help ensure proper cooling
air flow.