Cisco Cisco Prisma II EDR Receiver Installationsanleitung
2-8
Installation
78-748705-01 Rev C
Install the Processor in the Chassis
Introduction
The following instructions apply to front access and rear access chassis that are
already mounted in a rack.
Installing the Processor
Follow these steps to install the processor in the chassis.
1.
Locate the fiber guides at the bottom of the chassis and the module guide
slots inside the chassis as shown in the following illustration.
2.
Align the ridges on the top and bottom of the processor with the module
guide slots located on the chassis. Module ejectors must be fully extended
when inserting the processor.