Cisco Cisco Prisma II EDR Receiver Installationsanleitung
2-12
Installation
78-748705-01 Rev C
Connect Optical Cables,
Continued
Connecting an Optical Cable to an Optical Transmitter
This procedure assumes that the optical transmitter has not been installed in the
processor.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
Follow these steps to connect an optical cable to each optical transmitter to be
installed.
1.
Attach one end of the optical cable to the optical output connector located on
the front of the optical transmitter.
2.
Route the other end of the optical cable to the appropriate destination.
3.
Repeat steps 1–2 for the second optical transmitter.