Cisco Cisco OptoStar II 1550nm EDFA Installationsanleitung
Operating using Console Software
This section introduces the procedures to use the OptoStar II console to manage
the OptoStar II 1550 nm DWDM forward direct modulation transmitter module.
the OptoStar II 1550 nm DWDM forward direct modulation transmitter module.
Before You Begin
•
One PC
•
Mini-USB data cable
•
OptoStar II console software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Vista, Windows Server
2003, and Windows XP
2003, and Windows XP
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 96 MB (minimum requirement); 256 MB (recommended)
•
Hard drive: 500 MB free space required
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the fiber and RF cables of the OptoStar II 1550 nm DWDM
forward direct modulation transmitter module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the 1550 nm DWDM forward direct
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
Continued on next page
OL-29668-02
Operation
3-19