Cisco Cisco OptoStar II Reverse Receivers Installationsanleitung
Operating using NMS Software
This section introduces the procedures to use the OptoStar II network
management system (OptoStar II NMS) to manage the OptoStar II 1550 nm
DWDM forward direct modulation transmitter module.
management system (OptoStar II NMS) to manage the OptoStar II 1550 nm
DWDM forward direct modulation transmitter module.
Before You Begin
•
One PC
•
A network cable
•
OptoStar II NMS software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Server 2008, Windows
Vista, and Windows Server 2003
Vista, and Windows Server 2003
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 512 MB (minimum requirement); 1 GB (recommended)
•
Hard drive: 500 MB free space required
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the fiber and RF cables of the OptoStar II 1550 nm DWDM
forward direct modulation transmitter module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the 1550 nm DWDM forward direct
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
Continued on next page
3-26 Operation
OL-29668-02