Cisco Cisco OptoStar II Platform Installationsanleitung
Installing / Removing the Modules
To Install the Module
Install the ICIM module and power supply module first. See Cisco OptoStar II
Intelligent Communications Interface Module (ICIM) Installation and Operation
Guide, part number: OL-29660 and Cisco OptoStar II Chassis (CH) and Power
Supply (PS) Installation and Operation Guide, part number: OL-29659 for
details.
Now you may start to install the OptoStar II 1550 nm DWDM forward direct
modulation transmitter module. Connect it to the rear panel connector of the
chassis. Install the module as shown in the following illustration.
Intelligent Communications Interface Module (ICIM) Installation and Operation
Guide, part number: OL-29660 and Cisco OptoStar II Chassis (CH) and Power
Supply (PS) Installation and Operation Guide, part number: OL-29659 for
details.
Now you may start to install the OptoStar II 1550 nm DWDM forward direct
modulation transmitter module. Connect it to the rear panel connector of the
chassis. Install the module as shown in the following illustration.
1. Select Slot 4 – Slot 17.
2. Inspect all the pins on the rear panel and confirm that they are not bent.
2. Inspect all the pins on the rear panel and confirm that they are not bent.
3.
Hold module vertically with module front towards you.
4.
Align the rib on lower side of the module with a guide slot in the chassis and
align top rib with matching guide slot in the top of the chassis.
align top rib with matching guide slot in the top of the chassis.
5.
Slide module in smoothly until you feel slight resistance, then continue to
push gently until the module connector seats completely.
push gently until the module connector seats completely.
Note: Check alignment if you feel significant resistance. Do not press hard,
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
6. Tighten the mounting screws on the lower front panel of the module by hand
or screwdriver, to secure the module in the chassis.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
7. Repeat the steps above if more modules need to be installed.
8. Connect the fiber and RF cables.
8. Connect the fiber and RF cables.
Continued on next page
2-4
Installation
OL-29668-02