Cisco Cisco OptoStar II 1550nm EDFA Installationsanleitung
Installing/Removing the Power Supply Module, Continued
To Remove the Power Supply Module
1. Confirm that the power switch is turned off (OFF), and remove the power
cable from the rear panel.
2. Loosen the mounting screws on lower front panel of the module by hand or
screwdriver, to release the module from the chassis.
3. Pull out the module slightly to unseat the connector.
4.
4.
Hold the module and gently remove it from the chassis
Note: Do not use the mounting screws as a handle when removing the module.
Follow the steps as shown in the following illustration.
Follow the steps as shown in the following illustration.
2-10
Installation
OL-29659-03