Cisco Cisco OptoStar II Platform Installationsanleitung
Operating using Console Software
This section introduces the procedures to use the OptoStar II console to manage
the OptoStar II forward driver amplifier module.
the OptoStar II forward driver amplifier module.
Before You Begin
•
One PC
•
Mini-USB data cable
•
OptoStar II console software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Vista, Windows Server
2003, and Windows XP
2003, and Windows XP
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 96 MB (minimum requirement); 256 MB (recommended)
•
Hard drive: 500 MB free space required
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the RF cables of the OptoStar II forward driver amplifier
module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the forward driver amplifier module
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
warm-up.
Continued on next page
3-16
Operation
OL-29667-02