Cisco Cisco Prime Collaboration Assurance 11.5 Weißbuch
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 36 of 38
You also need to include test phones and test probes in an XML file. Test phones are the phones that actually
perform the phone functionality (call, call forward, call conferencing, call park, and call hold). Test probes are the
other phones that participate in the phone tests.
For instance, the call conference test would be:
●
Place a call from phone A to phone B
●
From phone A, conference to phone C
You should define phone A as a test phone and phones B and C as test probes in XML.
The call-forward test would be:
●
Place a call from phone A to phone B
●
Forward the call to phone C by way of phone B
●
Verify that the call is received by phone C
Then, in your XML test file, define phone A as a test phone, and define phones B and C as test probes.
Resolving Batch Test Failure
No events or alerts are generated when a component of a batch test fails. You must use the Batch Test Results
report to see the results of a batch test. A new Batch Test Results report is generated every 24 hours for each
batch test. The Batch Test Results report provides any error message for the individual tests that are a part of the
batch test, and this might help you resolve the batch test failure.
●
When the error message displayed is “Unable to create provider - Connection refused: connect”: Make sure
that Cisco Unified Communications Manager CTI service is activated and the JTAPI user is created on
Cisco Unified Communications Manager.
●
When the error message displayed is “Unable to create provider - bad login or password”: Make sure that
you include the same JTAPI user/password you have defined on Cisco Unified Communications Manager in
the XML file.
●
When the error message displayed is “Invalid phone address XXXX for the CCM XXXX”: Make sure that
test phones and test probes are associated with the JTAPI user in the Cisco Unified Communications
Manager configuration.
●
When the error message displayed is “Address XXXX is not in provider’s domain”: Make sure that test
phones and test probes are in your phone inventory. Run the phone inventory collection to bring newly
added phones to the Cisco Prime Collaboration Assurance inventory.
●
When the error message displayed is “The test did not complete in the stipulated 30 seconds”: Make sure
no other synthetic test is run on the same test phones and test probes. It is also recommended that you run
the individual test manually if you expect the test to be successful.