Cisco SA III High Gain Dual with 40 51 MHz Split Installationsanleitung
GainMaker Amplifier AGC Module Replacement
Installation Instructions
Installation Instructions
Overview
Introduction
This document explains how to replace an automatic gain control (AGC) module in a
GainMaker
GainMaker
®
System Amplifier and GainMaker Line Extender amplifier. This
replacement procedure should be performed on amplifiers that require an AGC
module other than the one that was factory-installed.
module other than the one that was factory-installed.
Audience
These instructions are intended for service personnel who are responsible for
installing and maintaining GainMaker products. The personnel should have
experience with hardware component installation.
installing and maintaining GainMaker products. The personnel should have
experience with hardware component installation.
Document Version
This is the third release of this document.
Related Publications
Refer to the following publications for more information about GainMaker
amplifiers.
amplifiers.
GainMaker Broadband Amplifier Platform System Amplifier Modules and Housings
Installation and Operation Guide, part number 593161
Installation and Operation Guide, part number 593161
GainMaker Broadband Amplifier Platform Line Extender Modules and Housings
Installation and Operation Guide, part number 593057
Installation and Operation Guide, part number 593057
Continued on next page